A process is currently executing in the background, please wait for the operation to complete. Once complete your screen will refresh automatically. One moment please...

For Zinc and Aluminum Die Casting
Used with Standard Replacement Units

Call a DME Customer Serivce Representative for a quote or to place an order:
If calling within the USA, please call 1-800-626-6653
If calling within Canada, please call 1-800-387-6600

DCS-108 Single-Unit Die Holder Only

  • Center Section: DME No. 5 Steel (H-13 type), heat-treated to 42-46 HRc
  • Top Clamping Plate: DME No. 2 Steel (AISI 4130 type), pre-heat treated to 269-321 Bhn (28-34 HRc)
  • Ejector Housing: High Carbon Steel or DME No. 2 Steel (AISI 4130 type), pre-heat treated to approximately 269-321 Bhn (28-34 HRc)
  • For Zinc: Spreader and Bushing specified by you will be installed.  Cost of Spreader, Bushing and installation included in List Prices.
  • For Aluminum: Straight shot sleeve hole bored to your specifications, included in List Prices.  (Please supply a dimensioned drawing)

DCS-1012, DCS-1215 and DCS-1518 Single-Unit Die Holders

  • Center Section: DME No. 5 Steel (H-13 type), pre-heat treated to approximately 42-46 HRc
  • Top Clamping Plate: DME No. 2 Steel (AISI 4130 type), pre-heat treated to 269-321 Bhn (28-34 HRc)
  • Ejector Housing:
    • DCS-1012 and DCS-1215 Only: High Carbon Steel or DME No. 2 Steel (AISI 4130 type), pre-heat treated to 269-321 Bhn (28-34 HRc)
    • DCS-1518 Only: DME No. 2 Steel (AISI 4130 type), pre-heat treated to 269-321 Bhn (28-34 HRc)
  • For Zinc: Spreader and Bushing specified by you will be installed.  Cost of Spreader, Bushing and installation included in List Prices.
  • For Aluminum: Straight shot sleeve hole bored to your specifications, included in List Prices.  (Please supply a dimensioned drawing)

Note: Individual plates used in a Unit Die Holder construction, are available on special order. Also, when setting up for a die casting process, it is recommended that the two halves of the mold are not closed at full force at the end of the mold-closing motion within the die casting press.

CAD Data
Catalog Page
Dimensions for Die Cast Replacement Units and Holders

For questions on Die Cast mold design methodology, please refer to the NADCA website for more info

There are no records to display

P r o c e s s i n g . . .