Button Sensor used to Monitor and Control Injection Molding Cavity Pressure.

• Button Sensor are usually installed under an ejector pin and the connector mounted permanently on the Mold.
• BSC-10 Button Extension Cable connects the sensor to the IPC-01-01 Cavity Pressure Controller. This cable can be cut to connect to other applications.
• 2,000 Lbf Sensor Series BS-413C - XX, NOTE: DO NOT CUT sensor Cable, Calibration Resistors built in Cable
• 500 Lbf Sensor Series BS-412C - XX, NOTE: DO NOT CUT sensor Cable, Calibration Resistors built in Cable
• 125 Lbf Sensor Series BS-411C - XX, NOTE: DO NOT CUT sensor Cable, Calibration Resistors built in Cable
• 350 Ohm Stain Gauge Design

For assistance in configuring a system with the items listed below, please contact D-M-E Customer Service at 248-398-6000 or click here.

Product Information
DME Control Systems Product Brochure Pages

Product Accessories ( Some Items only available through special order )
Cavity Pressure Controller IPC-01-01
See Also - Cavity Pressure Slide Sensors

Technical Information

CAD data for Button Sensor Extension Cable
Sensor Cables
A Short Tutorial on Cavity Pressure Transducers Usage
Technical Literature for D-M-E Pressure Transducers - Revision 1.2
IPC-01-01 Pressure Control Overview

General Information
Replacement Parts (RPM's) & Upgrade kits (see Product Information - Users Manual for RPM list)
Technical Guides
Product Documentation